MG TD / Classic TD (1952 MG Replica)

Hold Down, Rear Engine, MG Replica (Each)

Hold Down With Clip.

Hold Down, Screw Set S/S Screws, Nylocks, Washers..

Hood or Trunk, Edge Molding Trim (Per Foot)

Gazelle / SSK and MG TD Fiberglass Edge Molding.  Give a finished look to the edge of fiberglass in the Hood and Trunk compartments. Black 3/16" -1/4" thick 5/8" height, Flexible Interior And Exterior(Per Foot). No Refund on custom cut.

Hood Strap, Hardware Set

Set Includes: Three Footman Loops, Six; Screws, Washers, and Nuts. Hole spacing on the footman loops are 3 1/8" on center.

Hood Strap, Leather MG TD Replica

MG TD Replica Hood Strap specifically designed to be mounted above the molded-in louvers.   Comes with Mounting Hardware (2 Footman Loops and Stainless steel Screw Set). Strap is adjustable from 34 1/2" to 40 1/2".

Hood, "Strip End Cap" MG Fiberfab MiGi Replica (Chrome)

Hood Strip End Cap MG Fiberfab MiGi Chrome, used on Chrome Hood Strip Only.  

Hood, "Strip" MG Replica (Polished Stainless Steel)

Hood Strip MG Polished Stainless Steel with Finished Ends. 44 1/4" Long, 5/8" Wide, Comes with five Fasteners.

Hood, Gasket Cowl, MG Replica Rubber..

8' Long, will need to be adhered to the surface.

Hood, MG-TD Replica, Fiberglass Hood (Hood Only)

Fits Classic Motor Carriages "Classic TD" and Fiberfab "MG-TD". Fiberglass only, grey primer Gel Coat will need prep and paint to match. **It will need to be shipped freight, additional Freight shipping charges will be added after we receive a quote.**

Hood\Trunk, Support Slide

Telescoping Extends to 21 1/2".. Mount one end inside the Hood or Trunk compartment and the other end to the Hood or Trunk. Prop-up the trunk or hood and determine the placement, with the support in the up and locked position. If you do not want to...

Horn, Trumpet or Dual, Bug And Water Deflector (Pair)

Chrome ABS plastic with two stainless steel brackets and screw.

License Bracket, Front Plate (Gazelle / SSK or MG)

Bracket to mount front Plate (No Light).